InsideDarkWeb.com

Sanding & Oiling walnut slab table

I’m making a table out of two thick walnut slabs.
My question is in regard to the order of sanding and oiling.
I’m working on the underside now and put a coat of Tung oil on, thinking it’s good to put this down before attaching the legs.
When doing the top of the table, do I oil, sand repeatedly working my up to a fine course, then oil again? How many coats before/after sanding? I believe I want about 5 or so coats of tung oil.
I’m sure it’s obvious that this is my first technical (to me) wood project.

Thanks a bunch,
Jay

Woodworking Asked by JRudz on July 28, 2021

0 Answers

Add your own answers!

Related Questions

How do I calculate a miter angle?

1  Asked on March 27, 2021 by mr-mascaro

     

What is the mimumum bend radius for 6 mm Medite Tricoya Extreme MDF?

0  Asked on March 25, 2021 by petaspeedbeaver

   

What grit sandpaper should I use on my drumsander?

1  Asked on March 24, 2021 by wizlog

 

Track hardware for hanging plywood panels

1  Asked on March 10, 2021 by fakeer

 

Finish for MDF Worktable

4  Asked on March 7, 2021 by azulshiva

       

Remove and replace inset wooden handle

4  Asked on March 7, 2021 by daniel-k

   

Levelling off a surface for veneer

4  Asked on March 4, 2021

   

Using a 5/8 dado stack on a “30mm” arbor

2  Asked on February 28, 2021 by ryanjdillon

   

Ask a Question

Get help from others!

© 2021 InsideDarkWeb.com. All rights reserved.